WMW UNION BFP-130/6 Horizontal Floor Type Boring Mill, View full category

WMW UNION Horizontal Floor Type Boring Mill, Made in Germany

Model: BFP-130/6

Year    :  1980              

Technical Details (Subject to Verification)

Spindle diameter                     : 130 mm (5.1”)

Spindle Taper                         : ISO-50 with Power Draw Bar

Column Longitudinal Travel  : 5,550 mm (18' 3")

Head Vertical Travel              : 2,500 mm (98")

Column Cross Travel              : 400 mm (15.7")

Spindle Travel                        : 1,000 mm (39")

(27) Spindle Speeds                : 4.5 to 900 RPM

Facing Plate Diameter            : 850 mm (34") (covers the facing head)

Facing Head Diameter            : 785 mm (30.9") Diameter

(18) Facing Head Speed         : 4.5 to 180 RPM

Facing Head Travel                : 12.59"

Spindle Feeds                          : .03 to 48 MM Per Rev., & .0016 to 2.00 TPR

(36) Feeds to Head & Column           : .024 to 78.7 IPM

Spindle Drive Motor               :  18.5 KW, 3/60/480V

EQUIPPED WITH:

• Rapid Traverse
• Facing Head
• Universal Right Angle Milling Head with 24-1/2" Long Extension
• Tailstock with 2,000 mm (78") Power Vertical Travel & 39" Power Longitudinal Travel on the Base
• 3-Axs Acu Rite DRO:  Head Vertical Travel, Column Cross Travel & Spindle Travel
• Pendant Control
• Sliding Metal Way Covers on the Bed
• Wedge Type Levelling Pads
• All Hard Ways
• Note:  In 1989 Upgraded Ball screws & Fanuc Servo Drive to the Head Vertical Travel & the Column Transverse Travel.
• 5.5m X 1.8m (6' x 18' x7") Thick Floor Plate Floor Plate
• (6) 1-1/16" Tee Slots Running the 18' Length on 12" Centres
• (18) 1-1/16" Key Slots Running the 6' Width on 12" Centres
• (21) Levelling Screw Pockets on 33-1/2" Centres Width wise & Lengthwise
• (7) 10" Wide x 6' Long Levelling Pads Cast into the Bottom of the Table